Sort by
Position
Name: A to Z
Name: Z to A
Price: Low to High
Price: High to Low
Created on
Display
36
48
72
per page
QBM3700../MO different models:
Range of Measurement:
Bandwidth: 70MHz
Laser Thermometer Anemometer
AC 50V ~ 600V Voltage Detectors
Spectral Range:8–14 µm
Image Frequency: 9Hz
Minimum Focus Distance:0.1 m
Minimum Measurement Distance:26 cm
Pixel Pitch:12 µm
Contact test range:2 to 20,000 RPM
Non-contact test range: 2 to 99,999 RPM
Accuracy:± 0.05% + 1digit
Range: 0.5~19999rpm
AC 90V ~ 1000V Voltage Detectors
Frequency (Hz): 50/60Hz
AC Voltage:6V/60V/600V
* 0 to 14 pH x 0.01 pH.
* ATC (automatic temperature compensation).
* pH control setting, Temp. control setting.
* pH control relay output, Temp. control relay output.
عملکرد به صورت پل ارتباطی 4 تا 20 میلی آمپر
Interchangeable intelligent sensor cell
Flammable gas detection 0 to 100% LFL/LEL
Operating humidity continuous 20-90% RH
ATEX / IECEx hazardous area approval
Up to 64 channels of detection and 128 output channels
Range of Measurement:
*Dual display Temp. & Conductivity or TDS with ATC
*Very useful tool to prevent heat stroke
*Programmable printing Bench Top pH / mV meter with Temp. & real time clock stamped
Measuring range : from 0/+10 Pa to -10 000/+10 000 Pa.
ABS or ALU IP 65 housing
water resistant
continuity buzzer
Automatic rang
90-1000V AC
Noncontact Voltalert
with Adjust Sensitivity
4,000 counts
Detection range 0.01 to 100 ppm
℃IR Temp. Range:-50 to 2200
Range 0-20% LEL, 0-100% LEL
Range of Measurement:
*Lowest cost pH pen
measurement from - 100 to + 100 Pa range
IP65
DC/AC voltage:600 V
ACA:600A,400A
DCA:600A,400A
Resistance:40 M ohm
Frequency :100KHz
Over 200,000 points of gas detection
Ammonia range:2.6-75.0 ppm
Flammable, toxic and Oxygen versions available
CO Measuring range 0...500 ppm
Operating voltage:AC 24 V / DC 13.5…33 V
DC: 400mV/4V/40V/400V/600V
AC: 4V/40V/400V/750V
Current Range 400/1000A
Ohms Resistance Range:400Ω -40MΩ
Frequency Range:100Hz-800KHz
Range of Measurement:
*Lowest cost pH pen
Resolution of infrared image: 32*32-1024 pixels
Resolution of infrared image: 160 x 120
Measuring range:170-9060 HLD
Measuring range:0-100HD
Measuring range:0-100HA
Measuring range:200-900 HL
Accuracy:±4HLD
* CMM (m3/min.), CFM (ft3/min.)
* m/s, ft/min, km/h, mile/h, knots, Temp.(oC/oF).
* 0.4 to 25.0 m/s., -P circuit.
Voltage:100V-260V
Current:0-16A
Power 0-3680W
Power Factor 0-1
4poles
DCA:200A,1000A
ACA:200A,1000A
Resistance: 2000 ohm
AC Voltage: 200 V/600V
DC Voltage: 200 mV /400 V/600 V
Range CH2O: 0~1000ppb
Range CH2O: 0~1000ppb
Range of Measurement:
*Lowest cost pH pen
range From 800 to 1100 hPa
ABS housing - IP 65
Measuring range 0 to +14 pH (Short-term to +80 °C max. 5 min)
Temperature Range:-9 to 50C
pH measurement range:3.5 to 9
Sunlight intensity range:
less than 500 Lux to more than 120,000 Lux.
Temperature Range:-20 to 60ºC
Accuracy:±0.5ºC
Humidity:0 to 100%RH
Accuracy:±3%RH
Temperature Range:-50 to 70ºC
Humidity:10 to 99%RH
AC Voltage:750V
DC Voltage:1000V
AC/DC Current:1500A
True Power:900kW
AC Voltage:15V/100V/300V/750V
AC Current:40A/100A/400A/1000A
True Power:0.60kW—750kW
Power Factor:0.3-1
Range of Measurement:
Range of Measurement:
Range of Measurement:
Range of Measurement:
Power supply:220V 50Hz Max 16A
Accuracy: 1.0
Constant: 6400imp/kWh
Power dissipation: <1W
from -100 to +100 Pa CPE 301
from -500 to +500 Pa CPE 302
from -1000 to +1000 mbar CPE 303
